Stools

juddnelson
Posts: 8
Joined: Sun Jun 08, 2014 3:19 pm

Stools

Unread post by juddnelson » Thu Jun 04, 2015 2:11 pm

I need help figuring out how to make a couple of bar stools.
They will look like stacking 4 different diam cylinders on top of each other.
Very modern looking.
Is there thin wall pipe that will work or do I need to roll each piece and then stack?
I can email you a photo.

Post Reply

Return to “Fabrication and Machining General Discussion Area”