cross instructions?

Have a question about blacksmithing? Need some help with a project? Ask here.
Post Reply
skipnord
Posts: 3
Joined: Wed Mar 06, 2013 9:48 am

cross instructions?

Unread post by skipnord » Mon Sep 02, 2013 4:48 pm

Does anyone know if there are instructions somewhere for forging a one piece cross? I think I saw one somewhere, but can't remember where, and have looked through all the publications I have saved.

Jim Ericksen
Posts: 67
Joined: Tue Mar 05, 2013 10:18 pm
Contact:

Re: cross instructions?

Unread post by Jim Ericksen » Mon Sep 02, 2013 9:20 pm

I believe you are looking for the "Fredericks" cross, basically you split the stock in half down 3/4 or so (also need to shorten one of the legs, easier to do after forging) , turn the stock 1/4 turn and split from the other direction and overlap the cut , heat and force the longer cuts apart and then force the shorter cuts apart and straighten , not sure on dimensions as its been awhile since ive made one and i usually just wing it, im sure a google search of "fredericks cross" will turn up more details if needed

jim

edit , I think I started with the shorter cuts finish with the longer cut < been awhile ;-)
Last edited by Jim Ericksen on Tue Sep 03, 2013 2:42 pm, edited 1 time in total.

User avatar
bbrown
Posts: 32
Joined: Mon Feb 11, 2013 6:37 pm
Location: Inver Grove Heights,MN

Re: cross instructions?

Unread post by bbrown » Tue Sep 03, 2013 8:57 am

Try these instructions.
Attachments
SCAN0197.JPG
Fredrich Cross Instructions
SCAN0197.JPG (1.24 MiB) Viewed 3282 times

Post Reply

Return to “Blacksmithing General Discussion Area”