Richtig knives

Martin Pansch
Posts: 314
Joined: Thu Feb 14, 2013 10:44 am
Location: Young America, MN

Richtig knives

Unread post by Martin Pansch » Thu Jan 01, 2015 5:44 pm

Being a metalsmith and history enthusiast I found this article interesting. Towards the end it talks about what a couple of metallurgists suppose Richtig's heat treating secret was. Sounds much like marquenching as described by Howard Clark and Mike Blue but I thought the said that only worked with steels like O1 and L6. Also it sounds like Richtig's holding temp of 600 F is much higher than the 425F or so described by Howard and Mike. I would think the 600 degrees would be too hot to give 1095 any kind of hard edge. Anyway, here is the article link. ... tig-knife/

Post Reply

Return to “Bladesmithing General Discussion Area”